Zmorph FAB - Laser Engraving;Cutting File Starting (with Calibration)

Product Manual - ZMORPH FAB back to table of content >>
141
14.5 Laser engraving/cutting le staing (with calibration)

Enter the ‘NEW JOB’ menu. Go to the ‘CHOOSE FILE’
section.
Files uploaded to the internal
SD card are located in the

to the SD card are located in
the ‘EXTERNAL’ tab.
Select the prepared G-code

 
is not visible on the list press
the up/ down arrow buttons
    
list.
Exiting the folder is done by
selecting the folder icon.
NOTE
If the user inserts the external SD card, the screen should jump forward to the ‘CHOOSE FILE’
section screen on the ‘EXTERNAL’ directory.
NEW JOB’ menu the screen will go
directly to the ‘CHOOSE FILE’ section.
Laser workow
NEW JOB MAINTENANCE
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK CANCEL NEXT
EXTERNAL
INTERNAL
example.gcode
CANCEL NEXT
EXTERNAL
INTERNAL
CANCEL NEXT
EXTERNAL
INTERNAL
CANCEL NEXT
EXTERNAL
INTERNAL
example.gcode example.gcode example.gcode