Zmorph FAB - Milling Cutter Fastening

Product Manual - ZMORPH FAB back to table of content >>
111
CNC milling workow
13.4 Milling cutter fastening
To ensure safe and reliable milling process, you must properly mount your milling cutter.
The process is the same regardless of cutter type and geometry.
Remove the CNC Milling
Toolhead from your machine.

adjustable wrench.

the shown slot.
Adjust the size of wrench to

collet fastening nut. Loosen
the nut.
Take out the old cutter if any
is inserted.
Put in a new cutter. Ensure

mm deep.
Firmly tighten the collet nut. Mount the CNC toolhead on
the X-carriage