Product Manual - ZMORPH FAB back to table of content
>>
17
How to use Zmorph Fab
6. How to use your
Zmorph Fab 3D printer
Then, the model has to be opened in a software dedicated by the manufacturer called Voxelizer. It allows
you to manage 3D printing, CNC milling and laser engraving. It is a unique original application for slicing 3D
and intelligent system of support structures. Voxelizer also has advanced algorithms such as projecting an
to the device using an SD card or imported to an internal memory using a USB connection. You can also
interruption, it is recommended to use an SD card.
the capabilities of the Zmorph Fab device and do not provide the support for CNC and Laser toolheads.
touch panel on the device, or by connecting to the device via Ethernet cable. It can be started directly from
the Internet browser on the computer.
The product is intended for indoor use only. The device is not protected against moisture and has no air
with plastics (e.g. ABS, Nylon), harmful fumes can be released.
To Next Page
Loading...
Need help?
General
