Product Manual - ZMORPH FAB back to table of content
>>
9
The device must be properly grounded. Always make sure that the grounding is in accordance with
local and national regulations.
Use only the original power cord or one authorized by the manufacturer. It must not be destroyed,
cut or repaired. Replace a damaged cable immediately with a new one.
Perform repair and maintenance work on the device when it is disconnected from the power
supply.
Do not expose the device to moisture or modify electronic components (e.g. soldering).
The device includes moving parts such as toothed belts, gears, motors, toolheads and a worktable. In order to
ensure maximum safety for the operator and the device follow these precautions:
Do not reach inside the unit or insert any foreign objects while the unit is during operation.
Use the accessories supplied with the unit for their intended purpose and take special care when
handling them. Their improper use may cause personal injury.
Special care must be taken when removing the printout from the worktable and protective glasses
should be worn, as there is a risk of fragments of the material scattering towards the eyes.
the toolhead with bare hands and use caution when operating hot components. If it is necessary to hold
a hot item, use specially adapted pliers and/or tweezers. The hot components should not take more than
respect to changes in operating temperature are not permitted, as they may result in serious injury or per-
manent damage to the printer.
2.4 Safety and mechanical risks
2.5 Risk of burns
Health and safety
The storage place should be free from moisture and extreme weather conditions.
2.6 Instructions for safe storage and transpo
To Next Page
Loading...
Need help?
General
