Product Manual - ZMORPH FAB back to table of content
>>
22
8.2 Components
X-axis - double-toothed belt system driven by a stepper
motor and stainless steel rods as guiding elements.
Used for movement of the Zmorph Fab toolhead. Must
be periodically lubricated to ensure a long life of the
machine.
Y-axis - double-toothed belt system driven by a
stepper motor and hybrid (linear/sliding) rails as
guiding elements. Used for movement of Zmorph Fab
worktable. Must be periodically lubricated to ensure a
long life of the machine.
Z-axis - axis driven by double stepper motors with
integrated trapezoidal screws and high-quality POM
trapezoidal nuts. Guiding elements are stainless steel
rods and linear bearings. Used for movement of X-axis
of Zmorph Fab machine. Must be periodically lubricated
to ensure a long life of the machine.
Machine specication
To Next Page
Loading...
