Product Manual - ZMORPH FAB back to table of content
>>
23
X-carriage/Toolhead mount - element responsible
for holding down toolhead, as well as automatic
calibration. X-carriage has linear bearings mounted
that slide on stainless steel rods and is also a housing
for a calibration element - strain gauge. Toolhead
mounting is described in of this manual.
designed lever and magnets system for quick and
work surfaces. worktable changing is described in
of this manual.
The bottom cover of the machine - responsible for
the protection of the motherboard and power supply
from external damage and dirt. Allows air exchange for
cooling internal electronics.
Machine specication
To Next Page
Loading...
