Product Manual - ZMORPH FAB back to table of content
>>
144
When the cutter is in its
local position, go to the ‘SET’
coordinates by pressing the
‘’ and
‘SET Z
Go back to the main menu
and choose ‘START’. Your
machine will start working.
ZX
Y
HOME X HOME ZHOME Y
SET Y = 0 SET Z = 0
BACK MOVE
SET X = 0
14.6 Laser Toolhead safety rules
Instructions for preparing the workplace and how to safely operate the Laser Toolhead on Zmorph Fab.
These types of lasers are extremely dangerous, they emit visible or invisible radiation and they cause
materials evaporated from the surfaces of illuminated objects. Depending on the material used, toxic
Workstation
shiny metal-chromed, nickel-plated, aluminized - or glass parts),
It is necessary to secure the room in which the Zmorph machine with Laser Toolhead is located and
not working before an unprofessional start-up (the key to the room should only be held by a person
authorized to operate the laser),
It is necessary to mark the entrance door to the room where the device with the attached Laser
Toolhead is used with an appropriate laser radiation warning sign,
Laser workow
CALIBRATE SETTINGSCHOOSE
FILE
STARTBACK
To Next Page
Loading...
