Product Manual - ZMORPH FAB back to table of content
>>
145
Laser beams warning sign
It is necessary to mark the entrance door to the room where the device with the attached Laser
Toolhead is used with the appropriate sign to wear protective goggles,
Eye protection required, wear protective goggles
Place in a visible place next to the laser workplace a label with the words ‘visible and invisible laser
Provide personnel and bystanders in the room where the laser device works with protective eye
shields (glasses, safety goggles) appropriate to the type of laser device,
The appropriate safety goggles are those which, in a visible place (e.g. on the outside of the frame)
of power will reach the eye and it is a radiation level that is completely safe for the human eye,
Provide personnel and bystanders staying in the room where the laser device works with mouth and
Electrical installation of the Zmorph Fab machine requires connecting it to a grounded socket,
Provide a room in which a working Zmorph machine with Laser Toolhead is installed in a valid powder
extinguisher, it should be located in an accessible place and marked with appropriate markings,
When installing the Zmorph machine with Laser Toolhead in a room where smoke detectors are
installed, make sure that they do not cause false alarms,
The room in which the Zmorph machine with the Laser Toolhead machine is located must be well
machine.
Laser workow
To Next Page
Loading...
