Zmorph FAB - Material Exchanging

Product Manual - ZMORPH FAB back to table of content >>
59
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
Tap the upper RIGHT arrow



prevent clogging. Repeat if
needed.

time. Tap down arrow with ALL description to feed both



12.5 Material exchanging
Single Extruder Toolhead 1.75
To preheat the extruder, follow these steps.
Choose ‘MAINTENANCE’
from the LCD touchscreen
menu.
Choose ‘LOAD FILAMENT’. Choose ‘PARK TOOL’, wait for
the machine to position the
toolhead. When done, choose
‘PLA’ to preheat the material.
3D printing workow
NOTE
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
PARK
TOOL
BACK
LEFT RIGHT ALL
LOAD/UNLOADTEMPERATURES
PARK
TOOL
BACK
NEW JOB MAINTENANCE
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
LOAD/UNLOAD
PLA
ABS
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
PARK
TOOL
BACK
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
Wait till the extruder reaches
the proper temperature. The
yellow ‘TEMPERATURES’ sign
will change colour from yellow
to green.
Tap the LOAD/UNLOAD
menu.
Tap the upper arrow on the



Repeat if needed.
  
  