Product Manual - ZMORPH FAB back to table of content
>>
156
Maintenance and operation
16. Machine maintenance
and operation
16.1 Basic maintenance
Maintenance work should be carried out regularly to keep the machine in good condition and to achieve
a high-quality printed object every time. Some parts of the machine require maintenance before each job
and some only periodically. Maintenance is not complicated or time-consuming. During the maintenance
process, the machine should be cooled down (preheat only if necessary) and disconnected from the power
source (turn on only if necessary).
It is recommended to equip yourself with additional protective equipment such as thermal insulation
gloves and safety goggles. The machine is supplied with a basic set of tools for maintenance and service.
The following tables summarize the maintenance and repair guidelines for the main components of the
machine, the tables are divided by place of inspection, necessary tools, and their frequency.
To Next Page
Loading...
