Zmorph FAB - Starting the Print

Product Manual - ZMORPH FAB back to table of content >>
101
12.12 Staing the print

3D printing workow
Choose ‘NEW JOB’. Choose ‘CHOOSE FILE’. Files uploaded to the internal
card are located in the

to the SD card are located in
the ‘EXTERNAL’ tab.
Select the previously prepared

select its name.
Exiting the folder is done
by selecting the folder icon.

choose ‘NEXT’.
NEW JOB MAINTENANCE
CANCEL NEXT
EXTERNAL
INTERNAL
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
CANCEL NEXT
EXTERNAL
INTERNAL
CANCEL NEXT
EXTERNAL
INTERNAL
CANCEL NEXT
EXTERNAL
INTERNAL
NOTE

will automatically start preheating.
The table can be prepared
by selecting ‘MOVE BED’ and
is described in the chapter
‘Preparing the worktable’.
Choose ‘START’. Printing will start automatically
when the extruder and the
table have reached the right
temperature.
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
PAUSE
ABORTSETTINGS
example.gcode
progress 20% 0h34m elapsed
example.gcode
example.gcode example.gcode example.gcode