Zmorph FAB Manual Guide

Product Manual - ZMORPH FAB back to table of content >>
41
Maintenance
10.4 How to change the lter caridge
Choose ‘MAINTENANCE’ from
the LCD touchscreen menu.
Choose ‘MORE’. Enter the ‘HEPA FILTER’ menu.
Turn OFF the Filter. 
out from below.

from the metal holder.

cartridge and insert it to
the metal holder.

is on the outside
Reset the statistics for the

 Turn ON the Filtration system
NEW JOB MAINTENANCE
FILTER USAGE:
OFF
FILTRATION
SYSTEM
RESET STATS
/ 100%
BACK
NO YES
BACK
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
/ 100%
ON
FILTER USAGE:
FILTRATION
SYSTEM
RESET STATS
BACK
MAINTENANCE
MOVE
AXIS
FILTER
SETTINGS
INFO
BACK LESS
FILTER USAGE:
OFF
FILTRATION
SYSTEM
RESET STATS
/ 100%
BACK

Zmorph FAB Specifications

General

Build Volume	250 x 235 x 165 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Print Speed	up to 100 mm/s
Software	Voxelizer
Dimensions	530 x 555 x 480 mm
Layer Resolution	0.05 - 0.3 mm
Connectivity	USB, Ethernet
Supported Materials	PLA, ABS, PETG, TPU, Nylon
Power Supply	24V DC
Print Technology	Fused Filament Fabrication (FFF)
Extruder Type	Single Extruder
Display	5-inch capacitive touchscreen