Product Manual - ZMORPH FAB back to table of content
>>
157
16.2 General procedures
To Do Tools Frequency Solution
Cleaning the work
area from model
residues and
chips.
vacuum
cleaner,
fast
evaporating
cleaners
(containing
alcohol)
compressed
air
Before
each job
For the safety of the machine, the vacuum
cleaner pipe should not be made of metal
or it should have a plastic cap. When the
worktable is removed from the machine, using
the vacuum cleaner pipe with a plastic cap,
remove all bits of material and residues from the
work area. The side covers can be disassembled
for better access. If there is not a lot of dirt,
disassemble all covers and use compressed air
to blow out the bits of material.
Cleaning the
interior of the
machine and the
power supply
from dust
compressed
air
Every
working
hours
To clean the machine electronics from dust,
lay it on its side. Be careful not to damage it. The
mainboard and its cooling fan can be blown with
spray air through the holes in the bottom cover.
The power supply electronics can be blown
through the ventilation holes in the power supply
case.
working hours
months
Maintenance and operation
To Next Page
Loading...
