Product Manual - ZMORPH FAB back to table of content
>>
158
16.3 Worktable procedures
To Do Tools Frequency Solution
Cleaning the
surface
of the glass
worktable
dry cloth
fast
evaporating
cleaners
(containing
alcohol)
paper towel
spatula
Every couple
of prints
To remove the old adhesive from the surface
of the worktable use a piece of damp cloth and
a cleaning agent. The worktable should be
cold. If there are any plastic parts on the table,
remove them with a spatula.
Checking the
surface of the
glass worktable
for any damage
Before
each job
The surface of the glass sheet should be
inspected to ensure there is no chipping or
cracking.
Calibrating
(leveling)
the worktable
After
changing the
toolhead
Auto calibration or manual calibration must be
performed each time the toolhead or nozzle is
changed in the toolhead.
Maintenance and operation
To Next Page
Loading...
