Product Manual - ZMORPH FAB back to table of content
>>
28
Setting up Zmorph Fab
9. Setting up Zmorph Fab
9.1 Location requirements
After unpacking, place the machine in a suitable location.
Do not cover the machine with any materials during operation.
The machine should not be exposed to moisture.
The electrical installation of Zmorph Fab requires it to be connected to a grounded wall outlet.
Do not use extension cords.
for the HEPA Filtration system cover) .
It is recommended that the room in which the machine is located should be well ventilated, as
hazardous vapors may escape from the machine during operation.
min.
min.
To Next Page
Loading...
