Zmorph FAB - 500 D Printing Workflow; Toolheads

Product Manual - ZMORPH FAB back to table of content >>
50
3D printing workow
12. 3D printing workow
12.1 Toolheads
Single Extruder Toolhead 1.75mm

         
all materials available on the market such as: ABS, M-ABS, PLA, HIPS, Flex, PVA, PET, ASA and similar. The

Specication:
 Construction: High-quality 3 mm
aluminium frame
 
 
 
 
 
 Extrusion: Direct drive
 
 Recommended printing resolution:

 Supported printing resolution:

 
Cooling fan
Nozzle
Thermistor
Heating block
Heat break
plug (A, B)
Pressure adjustment screws
Toolhead cables
(left, right)