Zmorph FAB - Page 51

Product Manual - ZMORPH FAB back to table of content >>
51
3D printing workow
Dual Extruder Toolhead


materials available on the market as: ABS, M-ABS, PLA, HIPS, Flex, PVA, PET, ASA and others. Default nozzle

Specication:
 Construction: High-quality 3 mm
aluminum frame
 Hot End: Zmorph interchangeable Mixer
Hotend
 Temperature control: 2 thermistors
 
 
 
planetary gear x2
 Extrusion: Direct Drive
 
 
mm
 

 
Cooling fan
Extruder gear
Nozzle
Heating block
Thermistor
Heat break
plug (A, B)
Pressure adjustment screws
Stepper motor 1,75
Toolhead cables (left, right)