Zmorph FAB - Manual Calibration Process

Product Manual - ZMORPH FAB back to table of content >>
74
If after the second round of calibration the user still decides that none
of the lines are accurate, the machine will show a warning screen and
advise to repeat the automatic calibration process or to perform the
manual calibration.
3D printing workow
NOTE
If meeting calibration issues or autocalibration doesn’t work, please contact Technical Support
12.8 Manual calibration process

Choose ‘MAINTENANCE’. Choose ‘CALIBRATE’. Choose ‘MANUAL CALIBRATION’.
Wait until the extruder is
placed in the right place.
Clear the nozzle and the
table from the unnecessary
material.
Take a small sheet of paper
and place it between the
nozzle and the worktable.
Press the ‘’
button.
Move Z-axis to make the nozzle barely
touching the bed and click “Set new Z0”
GO TO
CURRENT Z=0
Z
Z
SET NEW
Z=0
MOVE Z
BACK
Calibration
result inaccurate
REPEAT
MANUAL
BACK
LOAD
FILAMENT
CHANGE
TOOL
CALIBRATE
3D PRINTING
BACK MORE
CALIBRATION
AUTO
3-POINT
BACK MORE
MANUAL
CALIBRATION
NEW JOB MAINTENANCE
