Zmorph FAB Manual Guide

Product Manual - ZMORPH FAB back to table of content >>
77
3D printing workow
12.10 Preparing the worktable
Choose ‘NEW JOB’. Choose ‘MOVE BED’. Wait until the worktable stops.
Positioning the worktable
works in two variants: to the
front and to the back of the
machine.
The variants are changing
with every click on ‘MOVE
BED’ option.
Clean the surface of the table
and remove all greasy spots.
We recommend paper towel
and a window cleaner.
Apply a thin layer of an
adhesive agent to the
worktable. The table is ready
for 3D printing.
NEW JOB MAINTENANCE
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK
CHOOSE
FILE
PREHEAT
PRINTER
MOVE
BED
SETTINGS
STARTBACK

Zmorph FAB Specifications

General

Build Volume	250 x 235 x 165 mm
Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Print Speed	up to 100 mm/s
Software	Voxelizer
Dimensions	530 x 555 x 480 mm
Layer Resolution	0.05 - 0.3 mm
Connectivity	USB, Ethernet
Supported Materials	PLA, ABS, PETG, TPU, Nylon
Power Supply	24V DC
Print Technology	Fused Filament Fabrication (FFF)
Extruder Type	Single Extruder
Display	5-inch capacitive touchscreen