Product Manual - ZMORPH FAB back to table of content
>>
6
1. Manual guide
Manual guide
1.1 Introduction
1.2 Markings contained in the instructions
guide and on the device
This manual describes the basic information about Zmorph Fab, safety precautions, preparation for oper-
time. Ignorance of the instructions may result in damage to the device, personal injury or reduced quality of
the printed parts. Make sure that everyone who uses the device has read and followed these instructions.
and disposal is at the highest level. However, the manufacturer has no direct control over the user and the
use of the device, therefore he is not liable for injury, damage and costs resulting from non-compliance
with these instructions.
Moving parts hazard - to avoid injury or damage to parts of the body, do not reach inside the
unit or insert any foreign objects while the unit is in operation, during operation or at rest.
High voltage - this symbol indicates the area where the user may be electrocuted.
Hot surface - this symbol warns of high temperatures to avoid burns.
Zmorph Fab Nameplate
Name: All-In-One 3D Printer
Type/model: Zmorph FAB
AC: 110-240V, 50-60Hz
Caution! The removal of the bottom
plate may result in loss of warranty.
Serial number:
Max power output: 350W
Produced: 2020
Weight netto: 20kg
Made in Poland
1001/FAB
To Next Page
Loading...
Need help?
General
