Zmorph FAB - Page 27

Product Manual - ZMORPH FAB back to table of content >>
27
Electrical specications
Soware specications
HEPA lter specication
Power supply


Power consumption 
 
Dual Extruder Toolhead power consumption 
CNC Milling Toolhead power consumption 
Laser Toolhead power consumption 
Supplied software Voxelizer
 .stl, .obj, .step, .dxf, .png, .bmp
Minimum system requirements


Linux (experimental)
 HEPA/Carbon
Fan power 
Filter lifespan 
Filter dimensions 
Filter Cover dimensions 
Filter control Temperature based
* Available on demand,
** Depends on nozzle diameter,
*** Depends on mounted milling cutter dimensions
**** Engraving - only if the surface is covered with black paint.
Machine specication