Product Manual - ZMORPH FAB back to table of content
>>
146
Safety instructions for handling Laser Toolhead on Zmorph Fab
General information.
The Zmorph Fab machine with Laser Toolhead mounted should be used in a separate room with
out the possibility of outsiders getting in,
Regardless of the laser class, it is forbidden to look at the laser beam (i.e. to look into the opening
machine. Zmorph Fab machine and Laser Toolhead are not toys and can’t be used by children
without adult supervision,
If you notice any abnormalities in the operation of the machine, stop the process immediately with
the reset button (red button on the right side on the front panel of the machine) and contact the
Zmorph Technical Support,
Do not use a defective machine under the threat of losing the warranty,
any around) must always wear safety goggles, failing to comply with this recommendation may
result in damage or loss of sight,
Never open any covers under which the machine components are hidden with the power supply
Technical Support,
Before starting work on the machine with Laser Toolhead, make sure that the machine’s
surroundings (work room) is closed and that there is no possibility of unauthorized access without
proper eye protection.
Safety at work with Laser.
Any exposure to laser emission may cause physical burns or damage to your eyesight. It is
extremely important to use the device in a safe manner and in accordance with the instructions,
The Zmorph Fab machine on which the Laser Toolhead is mounted and working can not be left
unattended,
machine to which the laser is connected,
The use and maintenance of the machine must always be carried out in a manner consistent with
the description in the manual,
Make sure that the room ventilation works correctly,
Install the workpieces and tools in the correct places in a safe manner. Avoid colliding the
workpiece with the machine. Otherwise, the machine may be damaged,
Laser workow
To Next Page
Loading...
