Product Manual - ZMORPH FAB back to table of content
>>
142
‘NEXT’.
Before starting the Laser engraving/cutting process the machine must be calibrated to the mounted material
on the worktable. Skipping the calibration process may result in damaging the machine or the toolhead.
Go to the ‘CALIBRATE’
section.
Press ‘SET’.
NOTE
The movement in the X and Y axes will be disabled until they are homed. It is a safety procedure, to
protect the machine against damage.
The movement in the Z axis is avaliable all the time. Use it to move the milling cutter above the
surface height of the prepared material.
The information on the Z axis height is stored in the motherboard internal memory. That is guided
by the fact that this value is not easy to change manually by the user unlike the X and Y axes.
Laser workow
CANCEL NEXT
example.gcode
X Y Z
MOVE ZMOVE X Y
BACK SET
CALIBRATE SETTINGSCHOOSE
FILE
STARTBACK
To Next Page
Loading...
