Product Manual - ZMORPH FAB back to table of content
>>
164
update detection should
countdown should start.
After this time the update
will begin automatically.
Choose ‘Yes’ to proceed and
skip countdow.
The machine will start
updating the LCD screens.
You must not remove the SD
printer during this process.
This process may take up to
will inform you about update
status.
After the successful update
the proper message will be
displayed. Restart the printer.
The machine is fully updated.
Firmware upgrades
NO YES
LCD screen update deceted.
It will start in 30 seconds
Do You want to proceed
Update completed!
Please restart the printer
Please wait
for the printer update.
It may take
up to 60 minutes
To Next Page
Loading...
