3Com Switch 4800G 24-Port - Page 1010

1010 CHAPTER 82: INFORMATION CENTER CONFIGURATION
Enabling the display of system information on the console
After setting to output system information to the console, you need to enable the
associated display function to display the output information on the console.
Follow these steps in user view to enable the display of system information on the
console:
Enable information center info-center enable Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
Refer to Table 77 for default
channel names.
Configure the channel
through which system
information can be output to
the console
info-center console channel
{ channel-number |
channel-name }
Optional
System information is output
to the console by default,
with channel 0 as the default
channel.
Configure the output rules of
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug
{ level severity | state state }
* | log { level severity | state
state } * | trap { level severity
| state state } * ] *
Optional
Refer to Table 79 for the
default output rules of system
information.
Configure the format of the
time stamp
info-center timestamp
{ debugging | log | trap
}
{ boot | date | none }
Optional
The time stamp format for
log, trap and debugging
information is date by
default.
To do… Use the command… Remarks
Table 79 Default output rules for different output destinations
Output destination Modules allowed
LOG TRAP DEBUG
Enabled/
disabled Severity
Enabled/
disabled Severity
Enabled/
disabled Severity
Console default (all modules) Enabled warnings Enabled debugging Enabled debugging
Monitoring terminal default (all modules) Enabled warnings Enabled debugging Enabled debugging
Log host default (all modules) Enabled informational Enabled debugging Disabled debugging
Trap buffer default (all modules) Disabled informational Enabled warnings Disabled debugging
Log buffer default (all modules) Enabled warnings Disabled debugging Disabled debugging
SNMP NMS default (all modules) Disabled debugging Enabled warnings Disabled debugging
To do… Use the command… Remarks
Enable the monitoring of
system information on the
console
terminal monitor Optional
Enabled on the console and
disabled on the monitoring
terminal by default.
Enable the display of
debugging information on
the console
terminal debugging Required
Disabled by default