3Com Switch 4800G 24-Port - Page 1013

Configuring Information Center 1013
Setting to Output
System Information to
the Log Buffer
Setting to Output
System Information to
the SNMP NMS
Configure the channel
through which system
information can be output to
the trap buffer and specify the
buffer size
info-center trapbuffer
[ channel { channel-number |
channel-name } | size
buffersize ] *
Optional
System information is output
to the trap buffer by default
with a default channel of
channel 3 (known as
trapbuffer) and a default
buffer size of 256.
Configure the output rules of
the system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug
{ level severity | state state }
* | log { level severity | state
state } * | trap { level severity
| state state } * ] *
Optional
Refer to Table 79 for the
output rules of the system
information.
Configure the format of the
time stamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
The time stamp format for
log, trap and debugging
information is date by
default.
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enable information center info-center enable Optional
Enabled by default.
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name
Optional
Refer to Table 77 for default
channel names.
Configure the channel
through which system
information can be output to
the log buffer and specify the
buffer size
info-center logbuffer
[ channel { channel-number |
channel-name } | size
buffersize ] *
Optional
System information is output
to the log buffer by default
with a default channel of
channel 4 (known as
logbuffer) and a default
buffer size of 512.
Configure the output rules of
the system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug
{ level severity | state state }
* | log { level severity | state
state } * | trap { level severity
| state state } * ] *
Optional
Refer to Table 79 for the
output rules of the system
information.
Configure the format of the
timestamp
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
Optional
The time stamp format for
log, trap and debugging
information is date by
default.
To do… Use the command… Remarks
Enter system view system-view -