Configuring an NQA Test Group 1057
n
The number of probes made in a UDP-jitter test depends on the probe count
command, while the number of probe packets sent in each probe depends on the
probe packet-number command.
Configuring the SNMP
Test
The SNMP query test is used to test the time the NQA client takes to send an
SNMP query packet to the SNMP agent and then receive a response packet.
Configuration prerequisites
The SNMP agent function must be enabled on the device serving as an SNMP
agent before the SNMP test. For the configuration of SNMP agent, refer to “SNMP
Configuration” on page 933.
Configuring the SNMP test
Follow these steps to configure the SNMP test:
Configure the source IP
address of a probe request in
a test operation
source ip ip-address Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Configure common optional
parameters
Refer to “Configuring
Optional Parameters Common
to an NQA Test Group” on
page 1062
Optional
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter NQA test group view nqa entry admin-name
operation-tag
-
Configure the test type as
SNMP and enter test type
view
type snmp Required
Configure the destination
address for a test operation
destination ip ip-address Required
By default, no destination IP
address is configured for a
test operation.
Specify the source port
number for a probe request in
a test operation
source port port-number Optional
By default, no source port
number is specified.
Configure the source IP
address of a probe request in
a test operation
source ip ip-address Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
To Next Page
Loading...
