1058 CHAPTER 86: NQA CONFIGURATION
Configuring the TCP Test
n
You are not recommended to perform an NQA TCP test on ports from 1 to 1023
(known ports). Otherwise, the NQA test will fail or the corresponding services of
this port will be unavailable.
The TCP test is used to test the TCP connection between the client and the
specified server and the setup time for the connection.
Configuration prerequisites
A TCP test requires cooperation between the NQA server and the NQA client. The
TCP listening function needs to be configured on the NQA server before the TCP
test.
Configuring the TCP test
Follow these steps to configure the TCP test:
Configure common optional
parameters
Refer to “Configuring
Optional Parameters Common
to an NQA Test Group” on
page 1062
Optional
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter NQA test group view nqa entry admin-name
operation-tag
-
Configure the test type as TCP
and enter test type view
type tcp Required
Configure the destination
address for a test operation
destination ip ip-address Required
By default, no destination IP
address is configured for a
test operation.
The destination address must
be the IP address of the
listening service configured on
the NQA server.
Configure the destination
port
destination port
port-number
Required
By default, no destination port
number is configured for a
test operation.
The destination port number
must be consistent with port
number of the listening
service configured on the
NQA server.
To Next Page
Loading...
