Configuring an Address Pool for the DHCP Server 803
Configuring WINS
Servers and NetBIOS
Node Type for the Client
A Microsoft DHCP client using NetBIOS protocol contacts a Windows Internet
Naming Service (WINS) server for name resolution. Therefore, the DHCP server
should assign a WINS server address when assigning an IP address to the client.
You can specify up to eight WINS servers in a DHCP address pool.
You need to specify in a DHCP address pool a NetBIOS node type for the client to
approach name resolution. There are four NetBIOS node types:
■ b (broadcast)-node: The b-node client sends the destination name in a
broadcast message. The destination returns its IP address to the client after
receiving the message.
■ p (peer-to-peer)-node: The p-node client sends the destination name in a
unicast message to the WINS server, and the WINS server returns the
destination IP address.
■ m (mixed)-node: A combination of broadcast first and peer-to-peer second.
The m-node client broadcasts the destination name, if no response, then
unicasts the destination name to the WINS server to get the destination IP
address.
■ h (hybrid)-node: A combination of peer-to-peer first and broadcast second. The
h-node client unicasts the destination name to the WINS server, if no response,
then broadcasts it to get the destination IP address.
Follow these steps to configure WINS servers and NetBIOS node type in the DHCP
address pool:
n
If b-node is specified for the client, you need to specify no WINS server address.
Configuring the BIMS
Server Information for
the Client
A DHCP client performs regular software update and backup using configuration
files obtained from a branch intelligent management system (BIMS) server.
Therefore, the DHCP server needs to offer DHCP clients the BIMS server IP address,
port number, shared key from the DHCP address pool.
Enter DHCP address pool view dhcp server ip-pool
pool-name
-
Specify DNS servers for the
client
dns-list ip-address&<1-8> Required
Not specified by default.
To do… Use the command… Remarks
To do… Use the command… Remarks
Enter system view system-view -
Enter DHCP address pool view dhcp server ip-pool
pool-name
-
Specify WINS server IP
addresses for the client
nbns-list ip-address&<1-8> Required (optional for b-node)
No address is specified by
default.
Specify the NetBIOS node type netbios-type { b-node |
h-node | m-node | p-node }
Required
Not specified by default.
To Next Page
Loading...
