804 CHAPTER 57: DHCP SERVER CONFIGURATION
Follow these steps to configure the BIMS server IP address, port number, and
shared key in the DHCP address pool:
Configuring Gateways
for the Client
DHCP clients that want to access hosts outside the local subnet request gateways
to forward data. You can specify gateways in each address pool for clients and the
DHCP server will assign gateway addresses while assigning an IP address to the
client. Up to eight gateways can be specified in a DHCP address pool.
Follow these steps to configure the gateways in the DHCP address pool:
Configuring Option 184
Parameters for the
Client with Voice Service
To assign voice calling parameters along with an IP address to DHCP clients with
voice service, you need to configure Option 184 on the DHCP server. For
information about Option 184, refer to “Option 184” on page 796.
If option 55 in the request from a DHCP client contains option 184, the DHCP
server will return parameters specified in option 184 to the client. The client then
can initiate a call using parameters in Option 184.
Follow these steps to configure option 184 parameters in the DHCP address pool:
To do… Use the command… Remarks
Enter system view system-view -
Enter DHCP address pool view dhcp server ip-pool
pool-name
-
Specify the BIMS server IP
address, port number, and
shared key
bims-server ip ip-address
[ port port-number ]
sharekey key
Required
Not specified by default.
To do… Use the command… Remarks
Enter system view system-view -
Enter DHCP address pool view dhcp server ip-pool
pool-name
-
Specify gateways gateway-list
ip-address&<1-8>
Required
No gateway is specified by
default.
To do… Use the command… Remarks
Enter system view system-view -
Enter DHCP address pool view dhcp server ip-pool
pool-name
-
Specify the IP address of the
primary network calling
processor
voice-config ncp-ip
ip-address
Required
Not specified by default.
Specify the IP address of the
backup network calling
processor
voice-config as-ip ip-address Optional
Not specified by default.
Configure the voice VLAN voice-config voice-vlan
vlan-id { disable | enable }
Optional
Not configured by default.
To Next Page
Loading...
