AAON ASM02780 - Prism 2 Manual Overview

3-2
Pioneer Gold 3.00 Controller Technical Guide
PRISM 2 OVERVIEW
Prism 2 Manual Overview
Prism 2 Technical Guide Overview
The Prism 2 Technical Guide will lead you through each step in

selecting units for troubleshooting. Below is a quick overview of
each step of the guide that pertains to the Pioneer Gold Controller.
Step 1: Installing Prism 2 - This section explains how to install
the Prism 2 software, initiate communications, navigate
the program, and enter and edit passcodes.
Step 2: Setting Up Job Sites - This section provides
instructions for setting up each job site’s name, port, or


Step 3: Conguring Prism 2 - This section describes how to
have Prism 2 automatically restart after a power failure
and broadcast time to all controllers. It also explains
how to set up the main screen display picture.
Step 4: Setting Up Communications - This section
explains how to establish communications via TCP/
IP connection through your CommLink.
Step 5: Searching for Installed Units - This section explains
how to perform a unit search per job-site.
Step 6: Selecting and Renaming Loops and Units - This
section explains how to select and rename loops and
units.
Step 7: Conguring Units - This section describes how to


The appendices include examples of status and setpoint screens,
instructions for DEMOMODE, and a list of controllers, E-BUS
modules, and other devices that can be updated using Prism 2.