8. Attach the drive module to the enclosure from top and bottom, see Assembly
drawing of installing the drive module to the enclosure (frame R10) (page 129)
(frame R10) or Assembly drawing of installing the drive module to the enclosure
(frame R11) (page 130) (frame R11). The top fastening bracket grounds the drive
module to the cabinet frame.
9. Attach the cabinet roof on the spacers and the side panels, see Assembly drawing
of installing the roof and door (page 131).
10. Remove the filter mats from the air filters according to Rittal’s instructions. Install
the filters to the cabinet door, see Assembly drawing of installing the roof and
door (page 131).
11. Drive modules with an external control unit (option +P906): Put back the removed
front covers of the drive module on the power cable sections, and connect the
control cables (see Connecting the control unit to the drive module (page 155).
Installation example with full cabling panels (option +H381) 127
To Next Page
Loading...
