Connector: RJ-45Control panel connection (X13)
Cable length < 100 m (328 ft)
Connector: RJ-45Ethernet connection (XETH [BCU])
This connection is not supported by the firmware
Memory card type: SDHCSDHC memory card slot (SD CARD
[BCU])
Maximum memory size: 4 GB
Real-time clock battery type: BR2032Battery
The terminals of the control unit fulfill the Protective Extra Low Voltage (PELV) requirements. The PELV
requirements of a relay output are not fulfilled if a voltage higher than 48 V is connected to the relay
output.
94 Control units of the drive