ABB HP CP500 - Install the Cabinet on the Foundation; Open the Cable Inlets

6.2.2 Install the cabinet on the foundation
Preliminary requirements
• Hoisting equipment or
forklift truck
• Torque wrench
• Four fasteners M16 and
washers
Procedure
1. Carefully lower the cabinet on the
foundation with a hoisting equipment
or a forklift truck. Refer to section
5.5.1.
Caution: Make sure that
there is no kink in the
cables.
2. Make sure that the holes in the cabinet
(A) and the foundation (B) are aligned.
3. Install the fasteners (C) and the
washers.
4. Tighten the fasteners to the correct
torque. For the specification, refer to
section 12.14.
6.2.3 Open the cable inlets
Preliminary requirements
• Open spanner
Procedure
1. Open the door. Refer to section 10.1.
2. Loosen the fasteners (A).
3. Move the sliding plates (B) to open the
cable inlets.
A
C
B
B A
Installation
38 9AKK107992A6488-EN | 004