Procedure
1. Guide the optical CAN cables to the
fibre-optics converter.
2. Remove the protection covers from
the optical connectors.
3. Connect these wires:
• Use the illustration as a reference.
• For the optical CAN cable
specifications, refer to section
12.19.6.
Wire from power cabinet Connect to charge post
(A) CAN bus fiber cable Rx (C) connection Tx at A100
(B) CAN bus fiber cable Tx (D) connection Rx at A100
4. Do not connect the two remaining fiber cables.
These fiber cables are spares.
5. Tie the CAN cables together.
a. Tighten the loops of the cables with cable ties.
b. Make sure that the loop bend radius is sufficient, to prevent damage to the
cable core. For the specification, refer to section 12.19.6.
8.7 Connect the Ethernet cable
Preliminary requirements
• Ethernet cable with an RJ45 plug. Refer to section 12.19.8
Note: Daisy chaining is not supported for Ethernet.
TX
RX
D2
Power cabinet Charge post
TX
RX
A100
DB
A C
Electrical installation of the charge post
60 9AKK107992A6488-EN | 004
To Next Page
Loading...
