Preparation of the lower arm before refitting of gearbox axis 2
Use this procedure to make the necessary preparations of the lower arm before
refitting gearbox axis 2.
NoteAction
xx1000000385
Clean the joint surface and guidance edge
on the lower arm as shown in the figure.
1
Parts:
• A: Joint surface (dashed line)
• B: Guidance edge
Preparation of the spare part before refitting of gearbox axis 2
Use this procedure to make the necessary preparations of the spare part before
refitting gearbox axis 2.
NoteAction
xx1000000380
Check that the spare part is painted as
shown in the figure.
1
• A: Unpainted surfaces
• B: Painted surfaces
Continues on next page
Product manual - IRB 6640 Foundry Prime 413
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.7.2 Replacing gearbox axis 2
Continued
To Next Page
Loading...
