NoteArt no.Spare part no.Equipment
M12x603HAB3409-71Attachment screw
Quality 12.9 Gleitmo
24 pcs
13x19x1.53HAA1001-134Washer
24 pcs
M12x503HAB7700-69Attachment screw
Quality 12.9 Gleitmo
33 pcs
3 pcs3HAC038648-001Washer
A new sealing must be used
on each assembly.
3HAC17212-1Sealing, axis 2/3
Replace if damaged!3HAB3772-68O-ring
For lubrication of o-rings3HAB3537-1Grease
Used to secure the upper
arm.
3HAC12708-1Mechanical stop axis
3
Use attachment screws
3HAB3409-86, M16x69
For mechanical stop axis 33HAA1001-186Washers
M16x603HAB3409-86Bolt
For mechanical stop axis 3
M123HAC025333-005Lifting eye
M12x2003HAC13056-3Guide pins
For guiding gearbox
Always use guide pins in
pairs!
M12x2503HAC13056-4Guide pins
For guiding gearbox
Always use guide pins in
pairs!
80 mm3HAC14628-1Guide pins
For guiding sealing ax 2/3
Always use guide pins in
pairs!
100 mm3HAC14628-2Guide pins
For guiding sealing ax 2/3
Always use guide pins in
pairs!
Content is defined in section
Standard tools on page 465.
-Standard toolkit
Complete kit that also in-
cludes operating manual
3HAC15716-1Calibration Pendulum
toolkit
These procedures include
references to the tools re-
quired.
Other tools and pro-
cedures may be re-
quired. See refer-
ences to these proced-
ures in the step-by-
step instructions be-
low.
Continues on next page
Product manual - IRB 6640 Foundry Prime 421
3HAC040586-001 Revision: N
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.7.3 Replacing gearbox axis 3
Continued
To Next Page
Loading...
