Reporting 139
Parameter logging interval templates
Use log intervals (Reports –> Settings –> Parameter logging interval templates ->
Settings –> Logging interval templates) to modify the logging intervals of multiple
parameters simultaneously instead of modifying the logging interval of parameters one by
one via the Parameter history logging tab.
With the log intervals function you can also bulk-change certain other attributes related to
parameters and reporting such as the reported parameter names and only the Log only
when changed selection on the parameter specific logging settings. All available logging
interval templates are matched to all connected monitored device parameters when the
Apply changes button is clicked. Templates are applied to newly connected devices also
when any new monitored device is connected to the NETA-21 (and after the device
interface has been reset to the default settings).
Use the Send template to tool… button to save a new template file to the NETA-21.
Under the Logging interval templates heading you can see the list of saved templates. If
you click the Run templates button, you can check some of the saved templates.
The Delete template button deletes the currently focused template file from the NETA-21.
The Run templates button runs the selected templates (all template files on the Logging
interval templates list which have been selected).
From firmware 2.22 onwards there is also a button to option Export template from
device… which shows a pop-up window with a drop-down list of all connected drives:
Select a device and click OK to export the currently selected configuration settings for the
parameter logging from the connected device into a file on a PC. The file can be edited
and imported (sent) to other NETA-21 tools.
To Next Page
Loading...
Need help?
General
