ABB NETA-21 - Cybersecurity Disclaimer

Program features 49
The services can be disabled as follows:
Cybersecurity Disclaimer
This product is designed to be connected to and to communicate information and data via
a network interface. It is Customer's sole responsibility to provide and continuously ensure
a secure connection between the product and Customer network or any other network (as
the case may be). Customer shall establish and maintain any appropriate measures (such
as but not limited to the installation of firewalls, application of authentication measures,
encryption of data, installation of anti-virus programs, etc) to protect the product, the
network, its system and the interface against any kind of security breaches, unauthorized
access, interference, intrusion, leakage and/or theft of data or information. ABB and its
affiliates are not liable for damages and/or losses related to such security breaches, any
unauthorized access, interference, intrusion, leakage and/or theft of data or information.
Service Navigation Action
ABB Netconfig Setting –> Network services –> Services –> Firewall
settings
Clear the check box of the
desired network interface.
FTP Setting –> Network services –> Services –> Firewall
settings
Clear the check box of the
desired network interface.
FTPS Setting –> Network services –> Services –> Firewall
settings
Clear the check box of the
desired network interface
HTTP Setting –> Network services –> Services –> Firewall
settings
Clear the check box of the
desired network interface
Note: HTTP protocol can
be disabled only if HTTPS
port setting has the default
value 443.
Modbus/TCP
gateway
Setting –> Network services –> Services –> Firewall
settings
Clear the check box of the
desired network interface.
PC tool gateway Settings –> Device interfaces –> Panel bus –> Settings Set Ethernet GW to
Disable.
NTP Settings –> Locale –> Date and time Set Time source to Manual
or External.
Network Time protocol settings Replace public NTP server
address with a local server
address.