148 Reporting
The available intervals are:
• Minute
• 5 minutes
• Hours
• Day
• None
• Continuous monitor.
• In firmware 2.21 the logging interval for Continuous monitor is 1second. In
firmware 2.23 the logging interval is adjustable between 1 … 30 s and the default
value is 5 seconds.
The signals are logged only if their values have changed. If the Log on when changed
check box is unchecked, the values are logged even if they have not changed.
Report events data tab
To see all sent reports and those errors that may have occurred after reports have been
created and sent, go to Reports –> Report events. The reports are sent to the email
address defined in section Creating an email report.
To Next Page
Loading...
