Reporting 147
• Parameter list shows all parameters in the selected interval. Multiple parameters can
be selected at the same time. If at least one parameter is selected, the parameter
properties panel is shown. The following columns exist:
• Parameter name
• Parameter group
• Device name
• Device id
• Interval.
• In the Parameter properties panel you can customize the logged signal name and
logging interval and select that logging is done either always or only when the signal
value has changed.
There are different ways to select multiple parameters:
• With the check boxes on the left of the parameters; add or remove parameters one by
one by clicking the check boxes
• To cancel the selection, click anywhere else in the row.
• With the Ctrl key; press the Ctrl key and click the rows you want to select.
• With the SHIFT key; hold down SHIFT and click the first and last rows of the selection.
To change the interval of parameters, select the parameters, choose the appropriate
interval from the drop-down list and click Apply changes. If you select multiple
parameters, you cannot edit the signal name and the signal logging history is not shown.
To Next Page
Loading...
