Devices 75
Parameter properties
Open the Parameter properties panel by clicking a parameter in the Name column. The
panel has two sub-panels that are visible one at a time.
• Modify panel has controls to modify the parameter value.
• Logging panel contains logging-specific settings and lists.
With the Modify sub-panel you can modify the parameter value.
The Modify sub-panel contains the following components:
• Value check box: There can be two value boxes to choose from depending on the
data type of the parameter. If there are two value boxes, only one of them can be
selected at a time, and the other is collapsed.
The box may be a spin box, check box grid, drop-down list, text editor or a parameter
selection control (parameter pointer or bit pointer). If there is the Parameter check
box, click the list to open a pop-up window where you can choose a parameter or the
bit of a parameter value.
To Next Page
Loading...
