ABB NETA-21 - Page 152

152 Tools
FMZAAvrr.NTU, where vrr represents a 3-digit version number (letters can be in upper
or lower case).
• Check updates button connects to ABB Download Center and checks for new NETA-
21 firmware releases. If a new version is found, it is downloaded and installed to the
device.
• Reboot tool button reboots the NETA-21, which triggers the software update if new
and selected firmware upgrade exists in the memory card. You are prompted to reboot
the NETA-21 after clicking the Reboot button.
• System information panel shows tool-specific information. The panel contains the
following fields: Remote monitoring tool type, Remote monitoring tool serial number,
Installed software, Software build version, MAC1 address and MAC2 address.
• Tool firmware updates panel shows all available firmware updates on the SD card.
The changes are saved and firmware installation settings are modified when you click
the Save button. The unchecked firmware files whose version number is not greater
than the version number of the currently installed firmware file are blacklisted and not
installed during the next reboot.
• Firmware column shows the file name of the file. The column contains also a check
box for defining whether the firmware update should be installed in the next reboot (if
the file is not checked, then NETA-21 does not try to install it). The check box is
disabled if the firmware is older than the current firmware or if it is the current firmware.
• Description column shows the status of the firmware update. The following conditions
may be seen:
• Old firmware is shown if the currently installed software is newer.
• Currently installed is shown if the file version equals to the currently installed
software.
• Non-installable is shown if the running OS version is factory-loaded (FMZALvrr)
and the same version as the update package (FMZAAvrr).
• Installation failed is shown if the number of the running OS version is smaller and
updating has failed.
• Not chosen to be installed is shown if the number of the running OS version is
smaller and the file is not checked.
• Install on next reboot is shown if the number of the running OS version is smaller
than the number of the currently installed firmware version. The NETA-21 tries to
install the OS during the next reboot.