7352 Series Digital Multimeter Operation Manual
6.6.3 ADC Command Reference
6-27
System Comparator
result buzzer
BP0 OFF –
BP1 The buzzer sounds when the comparator operation result is
FAIL.
–
BP2 The buzzer sounds when the comparator operation result is
PASS.
–
BP? Reply: One of BP0 to BP2 –
Measurement
data display
DS0 OFF
DS1 ON
DS? Reply: DS0 or DS1 –
Power supply
frequency
LF? Reply:LF0: 50 Hz
LF1: 60 Hz
–
Device
initialization
*RST Parameter initialization *RST
or Z
C Device clear
Device infor-
mation
*IDN? Reply: ADC Corp.,7352x,nnnnnnnnn,mmm
nnnnnnnnn:Serial No.
mmm:Revision No.
*IDN?
or
IDN?
Header H0 Header OFF
H1 Header ON
*1
H? Reply: H0 or H1 –
Output data
element
specification
ODEn 0 –
ODE? Reply: ODEddd –
Block
delimiter *6
DL0 CR/LF+EOI
DL1 LF
DL2 EOI
DL? Reply: One of DL0 to DL2 –
SRQ S1 Prohibition of SRQ transmitting
S0 Permission for SRQ transmitting
S? Reply: S0 or S1 –
*1: This is initialized when the instrument is shipped. This cannot be initialized by the *RST command.
*6: EOI is a GPIB function. EOI is not output in USB. The setting cannot be changed in an RS-232 interface.
Item
Command
Description
Va l i d
command
for the 2nd
display
setting
Initial
value
R6452
76543210
Specifies the calculation output
between 2 measurements.
Not used.
To Next Page
Loading...
