ADCMT 7352A User Manual

7352 Series Digital Multimeter Operation Manual
6.6.3 ADC Command Reference
6-29
System Operation
complete
*OPC Sets the operation complete bit (bit0) of the Standard Event
Status Register after all operations are complete.
–
*OPC? Reply: 1 (After all operations are complete.) –
*WAI Waits for the completion of all operations. (GPIB only) –
Self-Test *TST? Performs the self- test and reads the result.
(It takes time to perform the self-test. Read the result after
the *WAI command is executed.)
Reply 0 : Pass
1 : Fail
–
Calibration CAL0 Sets the calibration mode to OFF.
(Writes the calibration factor when leaving the calibration
mode.)
–
CAL1 Sets the calibration mode to ON. –
CAL? Reply: CAL0 or CAL1 –
XOUT Cancels (sets to OFF) the calibration mode.
(Does not write the calibration factor.)
–
PCn Enters the STD value. (Displayed count value)
n:0 to 999999
–
XDTn Enters the STD value. (Displayed value)
n: Displayed value on STD
–
CMNT
"str"
Sets the calibration information.
Enclose the character strings by using (") or (').
Up to 50 characters (one byte alphanumeric characters) can
be stored.
–
CMNT? Reply: CMNT"xxxx xxx" –
Setting
parameter
*SAVn n:0 to 3
Saves the setting parameters in area [n] of the nonvolatile
memory.
–
SINI Sets the values when shipping to all area from [0] to [3]. –
*RCLn n:0 to 3
Loads the setting parameters from area [n] of the non-
volatile memory.
–
RINI Loads the values when shipping as the setting parameters. –
Item
Command
Description
Va l i d
command
for the 2nd
display
setting
Initial
value
R6452
Up to 50 characters

ADCMT 7352A Specifications

General

Brand	ADCMT
Model	7352A
Category	Multimeter
Language	English