ADT Focus 200 Plus Installation And Setup Guide

FOCUS 200 PLUS Installation and Setup Guide
10-18
Level Privilege
4 Ability to change person/point/BA group descriptions, and privilege level. Ability to change
ID code accessibility to BA group.
5 Ability to bypass fire, holdup, or supervisory points, and to conduct FA sensor test.
6
Service − ADT on-premises signal is transmitted to CCC when the ID code is entered and
will lock out all other ID codes. This privilege must be assigned to all Service ID codes, and
is not to be made available to the customer.
7
Operating panel code and/or card/key code is permitted to be changed by person having a
code with Level 4 privilege.
8
Janitor − Use of valid card/key will cause the alarm shunting of any Janitor BA points in
the associated BA group(s).
Note: Basic privilege assigned to each code allows user to turn BA protection On and Off for assigned
BA group(s), and to perform tests.
Assigning Access and Privileges for Users
Perform the following steps to enter the card/key access data for a user via the operating panel. See the
ID Codes
section for the procedure on entering access capabilities of users using ID Codes.
Enter the Service Code at an operating panel.
< ? Enter choice:
< Lesson Turn on >
< See alarms Reset >
< Quit More >
Action Menu #1
is displayed.
Select
More
three times to display the last action menu.
< ? Enter choice:
< Sys info ID codes >
< Name pnt/gps Load >
< Previous First >
Action Menu #4
is displayed.
Select
ID codes
.
< PERSON #1
USER 001 Delete >
< Previous Change >
< Quit Next >
Person Data Entry Screen
is displayed.
Pressing the
[#]
key at this screen will bring you to the
Enrolling
Key or Card Screen.
Also pressing
Continue
at the last access
screen "ID code may (not) be changed" for BA Group 8 will bring
you to that screen.
< Insert or swipe
key or card
< 1 A 7 7 3 9 6 3
< Quit Continue >
The
Enrolling Key or Card Screen
is displayed.
Insert the key or swipe the card in the reader. An 8-digit number
will be displayed.
Select
Continue
to move to the next screen.
< ? Code and card
will be deleted
< on 08/21
< Quit Enter >
The
Person’s Deletion Date Screen
is displayed.
Enter the digits for the month and day after which the person will
be prevented from using the system.
Select
Enter
to register the date in the system.
< ? Code and card
will be deleted
< on 08/21
< Quit None >
After you press
Enter
, that button changes to
None
.
Select
None
to delete the date and/or change it.
< ? Code and card
will be deleted
< on 08/21
< Quit None >
Select
Quit
to return to the
Person Data Entry Screen
.

ADT Focus 200 Plus Specifications

General

Brand	ADT
Model	Focus 200 Plus
Category	Security System
Language	English