14-1
SECTION 14
Programming
•••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
♦
About Programming the System
♦
Mechanics of Programming
♦
Programming Names for the BA Groups
♦
Programming Point Data
♦
Programming the BA Groups' Turn-Off Data
♦
Programming the System Communication Options
•••••••••••••••••••••••••••••••••••••••••••••••••
About Programming the System
The installation may require the FOCUS 200 PLUS System’s data to be changed from the default
settings. This customization may be done either locally via an operating panel or remotely via downline
loading. The Hard ID number of each point, the various descriptors, and the user ID codes typically
need to be programmed into the system. Because the Hard ID numbers for the various points are
ordinarily not known until the sensors have been installed, this is typically done locally via an
operating panel. The Service Terminal telephone number and the subsystem group and instrument
numbers should also be entered.
Any data entered locally should be uploaded to the Service Terminal for future editing, as required.
Point Data
Point data is the information associated with point of protection in the system. This data includes:
•
The Hard ID Number
•
The name of the point (descriptor)
•
The point type
•
The associated BA group
•
Whether the point is linked to another point
•
Whether the point can be bypassed
•
The communication unit number
Descriptors
Descriptors are user-selected descriptive names. A user with a valid ID code and the appropriate
privilege level may at any time change the descriptors. Descriptors may be programmed for:
•
Each BA group
•
Each point of protection
•
Each person assigned an ID code
•
Each holiday in the holiday schedule
User ID Codes
The ID codes are user-selected, and are used to operate the system. See the ID Codes section for the
detailed programming procedure for entering the ID codes into the system.
To Next Page
Loading...
