ADT Focus 200 Plus Installation And Setup Guide

FOCUS 200 PLUS Installation and Setup Guide
20-4
Step Action
6 If you are using the backup dialer, temporarily disconnect the primary line and verify
signaling over the secondary line.
7 Verify that all signals have been received at the CCC.
8 Notify the CCC that the tests have been completed.
Testing the Printer
To test the printer, proceed as follows:
Step Action
1 Enter the Service Code to display Action Menu 1.
2
Select
More
twice to display Action Menu 3.
3
Select
History
to display the History Screen.
4
Select
On printer.
5
Select
Last 60 events.
6
Select
Start Print.
7 Verify that the printer is printing the last 60 events.
8
Select
Continue
and
Previous
twice to exit.
Finishing the Installation
To finish the installation, proceed as follows:
Step Action
1 Exit the Service mode, and select Reset ADT off.
2 Put all forms, which must be stored with the control unit, inside the front cover of the
cabinet.
3 Close and lock control unit cabinet.
4 Check that an instruction label is included on the back of each operating panel installed.
Instructing the Customer
Instruct the customer in the use of the operating panel, including the availability of the help screens.
Give the customer the FOCUS 200 PLUS User Guide.

ADT Focus 200 Plus Specifications

General

Brand	ADT
Model	Focus 200 Plus
Category	Security System
Language	English