ADT Focus 200 Plus Installation And Setup Guide

FOCUS 200 PLUS Installation and Setup Guide
19-2
Activating the Operating Panel
If the system is in a normal, non-alarm state, pressing any digit key activates the operating panel to
display the off/on status of the burglar alarm protective group(s).
Entering a valid 6-digit ID code causes the operating panel to activate, bringing up the Action Menus.
Then selections and entries can be made as required.
Screen Duration of the Operating Panel
If, while you are in the process of performing an operation, a predetermined period elapses without
making a selection, the display will revert to the screen showing the status of the system, provided that
all parts of the system are normal.
The various screen durations are as follows:
Screen Duration
Normal no-alarm 7 seconds
Action Menu #1 screen Approximately 10 seconds
After a selection at Action Menu #1 60 seconds
After an ADT Service Code is entered 4 minutes
Test In Progress Continuously until reset
Operating Panel Sounder
The operating panel sounder will annunciate to signal specific conditions as follows:
Condition Sounder Pattern
Each depression of a selector button or digit key A short beep
Acceptance of a valid code or a function A longer beep
Fire Alarm Pulsating 1-second-on, 1-second-off with a 5-
second pause every 10 seconds
BA Alarm Steady tone
Trouble or Supervisory Intermittent pulsating (2 beeps, 1 second off)
Entry Delay−reminder to turn off
Steady tone
Exit Delay−reminder to exit
1-second beep every minute
End of Exit Delay 4-second beep
Auto On Reminder−reminder to close (beeps start
15 or 30 minutes before closing, as programmed)
1-second beep every minute
Auto On Warning−warning to either exit or extend
closing time (beeps start either 5 or 15 minutes
after closing, as programmed)
Steady tone
Audible-on-Schedule Enable (if optioned) 1-second beep every minute
Test Mode in Progress 1-second beep every minute
During Audible Walk Test Pulsating 1-second-on, 1-second-off
When a sensor is activated during the walk test Steady tone
Action Menus
Operation of the system is based on selecting a course of action from menu items that appear on a
series of screens known as Action Menus. Provided the associated BA protection is off, entering a valid
ID code causes the first of four Action Menus to be displayed.
The Action Menus are the starting point for performing all operations other than turning the system
off. Selection of a menu item results in the display of another screen. Continue making selections until
the appropriate screen is displayed and the desired course of action has been completed.
The four Action Menus and the explanation for each of the keys at each menu follows.

ADT Focus 200 Plus Specifications

General

Brand	ADT
Model	Focus 200 Plus
Category	Security System
Language	English