ADT Focus 200 Plus Installation And Setup Guide

3-1
SECTION 3
Installing the Operating Panels
•••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
♦
About the Operating Panels
♦
Installing the Operating Panels
♦
Addressing the Operating Panels
♦
Operating Panel Programming Mode
♦
Adjusting the Contrast Level
•••••••••••••••••••••••••••••••••••••••••••••••••
About the Operating Panels
The FOCUS 200 PLUS system is controlled via a user-friendly operating panel. The system supports
up to 16 operating panels. The operating panel provides:
• An interactive 19-character four-line LCD (17 characters per line) display that operates in a
manner similar to an automatic teller machine (ATM).
• A numeric keypad similar to one on a TouchTone phone.
• An internal sounder, which annunciates for various situations, such as alarms, troubles, during
entry/exit delay, and whenever a key is pressed.
One operating panel can control all BA groups. Multiple operating panels will usually be needed in
installations:
• Involving two or more BA groups with separate entrance/exit paths.
• Where an operating panel must be installed inside of a separately protected area within the
premises.
• Where an operating panel is used in conjunction with an access point.
Operating Features
The operating features of the operating panel are as follows:
• Menus are employed to guide the user through the various operating procedures.
• Menu items and other selectable choices are shown on the screen with an arrow (>) that lines up
with one of the four selector buttons on each side of the screen.
• Help screens are available to assist the user in operating the system.
• The display screen and the numeric keypad become illuminated when any key is pressed. This
enables the operating panel to be used in dark or dimly lit areas.
• The customer can use the operating panel to change certain programming such as descriptors,
access codes, privilege levels, and permanent, temporary, and holiday schedules.
• The operating panel performs an automatic self-test whenever power is applied. If it passes the
power-on test, it will emit a single beep, flash the backlight, and display the following message:
ADT INTERACTIVE KEYPAD WAITING FOR COMM.

ADT Focus 200 Plus Specifications

General

Brand	ADT
Model	Focus 200 Plus
Category	Security System
Language	English